A solution of copper sulphate (CuSO) is electrolysed for 10 minutes with a current of 1.5 amperes. The mass of copper deposited at the cathode (at. mass of Cu = 63u) is :
- A
0.3892 g
- B
0.2938 g
- C
0.2398 g
- D
0.3928 g
Every Electrochemistry question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 227 questions across 8 distinct ideas. Free to read, answer key on every one.
Questions
227
Distinct ideas
8
Share of marks
4.4%
Difficulty
MEDIUM
A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Electrochemistry questions actually test.
201–220 OF 227 · NEWEST FIRST
A solution of copper sulphate (CuSO) is electrolysed for 10 minutes with a current of 1.5 amperes. The mass of copper deposited at the cathode (at. mass of Cu = 63u) is :
0.3892 g
0.2938 g
0.2398 g
0.3928 g
Given:
V; V
V; V
Based on the data given above, strongest oxidising agent will be:
Mn
MnO
Cl
Cr
The standard reduction potentials for , , and are , and V respectively. The reaction will be spontaneous when:
A battery is constructed of Cr and . The unbalanced chemical equation when such a battery discharges is following: $\text{Na}_2\text{Cr}_2\text{O}_7 + \text{Cr} + \text{H}^+ \rightarrow \text{Cr}^{3+} + \text{H}_2\text{O} + \text{Na}^+$ removed from the solution is
Given V, V. Standard electrode potential for the half cell is
0.38 V
0.53 V
0.19 V
0.49 V
The standard potentials of Ag/Ag, Hg/2Hg, Cu/Cu and Mg/Mg electrodes are and V, respectively. An aqueous solution which contains one mole per litre of the salts of each of the four metals is electrolyzed. With increasing voltage, the correct sequence of deposition of the metals at the cathode is
Ag, Hg, Cu, Mg
Cu, Hg, Ag only
Ag, Hg, Cu only
Mg, Cu, Hg, Ag
The reduction potential of hydrogen half cell will be negative if:
and
and
and
and
The Gibbs energy for the decomposition of at C is as follows: , kJ mol. The potential difference needed for electrolytic reduction of at C is at least
V
V
V
V
In a fuel cell methanol is used as fuel and oxygen gas is used as an oxidizer. The reaction is At K standard Gibb's energies of formation for and are and kJ mol respectively. If standard enthalpy of combustion of methanol is kJ mol, efficiency of the fuel cell will be
Given : V, V. The value of standard electrode potential for the change, will be :
V
V
V
V
Given . The potential for the cell is
0.26 V
0.399 V
V
V
The cell, ( V), was allowed to be completely discharged at 298 K. The relative concentration of to is
antilog (24.08)
37.3
The equivalent conductances of two strong electrolytes at infinite dilution in (where ions move freely through a solution) at are given below: S /equiv S /equiv. What additional information/quantity one needs to calculate of an aqueous solution of acetic acid?
of NaCl
of
The limiting equivalent conductance of ()
of chloroacetic acid ()
The molar conductivities and at infinite dilution in water at are and respectively. To calculate , the additional value required is
Given the data at , ; . What is the value of for ?
Resistance of a conductivity cell filled with a solution of an electrolyte of concentration is . The conductivity of this solution is . Resistance of the same cell when filled with of the same solution is . The molar conductivity of solution of the electrolyte will be
Two voltameters one of copper and another of silver, are joined in parallel. When a total charge flows through the voltameters, equal amount of metals are deposited. If the electrochemical equivalents of copper and silver are and respectively the charge which flows through the silver voltameter is
For a spontaneous reaction the , equilibrium constant () and will be respectively
-ve, >1, +ve
+ve, >1, -ve
-ve, <1, -ve
-ve, >1, -ve
The highest electrical conductivity of the following aqueous solutions is of
M acetic acid
M chloroacetic acid
M fluoroacetic acid
M difluoroacetic acid
Aluminium oxide may be electrolysed at C to furnish aluminium metal (Atomic mass amu; Faraday Coulombs). The cathode reaction is . To prepare kg of aluminium metal by this method would require
C of electricity
C of electricity
C of electricity
C of electricity
OTHER CHEMISTRY CHAPTERS