In an n-p-n common emitter (CE) transistor the collector current changes from mA to mA for the change in base current from A and A, respectively. The current gain of transistor is _____.
- A
- B
- C
- D
Every JEE Main question on Transistors (older syllabus), one of the ideas inside Semiconductor Electronics: 42 questions from 2004–2023, 28 of them in the last five years. Newest first, answer key on every one. Free to read.
Questions
42
Years asked
13
Since
2004
Of the chapter
17%
Questions on Transistors (older syllabus) in each year it was asked, the latest 12 of 13.
1–20 OF 42 · NEWEST FIRST
In an n-p-n common emitter (CE) transistor the collector current changes from mA to mA for the change in base current from A and A, respectively. The current gain of transistor is _____.
Given below are two statements:
Statement I: In a typical transistor, all three regions emitter, base and collector have same doping level.
Statement II: In a transistor, collector is the thickest and base is the thinnest segment.
In the light of the above statements, choose the most appropriate answer from the options given below.
Both Statement I and Statement II are correct
Both Statement I and Statement II are incorrect
Statement I is incorrect but Statement II is correct
Statement I is correct but Statement II is incorrect
For a given transistor amplifier circuit in CE configuration V, k, k and . Value of base current is

A
A
A
A
From the given transfer characteristic of a transistor in CE configuration, the value of power gain of this configuration is , for k, and k. The value of is _____.

The positive feedback is required by an amplifier to act as an oscillator. The feedback here means
External input is necessary to sustain ac signal in output.
A portion of the output power is returned back to the input.
Feedback can be achieved by LR network.
The base-collector junction must be forward biased.
For a transistor to act as a switch, it must be operated in
Active region
Saturation and cut-off region
Cutoff region only
Saturated region only
Given below are two statements : One is labelled as Assertion A and the other is labelled as Reason R.
Assertion A : transistor permits more current than a transistor.
Reason R : Electrons have greater mobility as a charge carrier.
Both A and R true, and R is correct explanation of A.
Both A and R are true but R is NOT the correct explanation of A.
A is true but R is false.
A is false but R is true.
For a constant collector-emitter voltage of 8 V, the collector current of a transistor reached to the value of 6 mA from 4 mA, whereas base current changed from to value. If transistor is in active state, small signal current gain (current amplification factor) will be
240
400
0.0025
200
An n.p.n transistor with current gain in common emitter configuration is shown in figure. The output voltage of the amplifier will be

0.1 V
1.0 V
10 V
100 V
A transistor is used in common-emitter mode in an amplifier circuit. When a signal of mV is added to the base-emitter voltage, the base current changes by A and the collector current changes by mA. The load resistance is k. The voltage gain of the transistor will be ______.
In an experiment of CE configuration of transistor, the transfer characteristics are observed as given in figure. If the input resistance is and output resistance is , the voltage gain in this experiment will be ______.

A transistor is used in an amplifier circuit in common emitter mode. If the base current changes by 100 A, it brings a change of 10 mA in collector current. If the load resistance is 2 k and input resistance is 1 k. The value of power gain is . The value of is ______.
The typical transfer characteristic of a transistor in CE configuration is shown in figure. A load resistor of is connected in the collector branch of the circuit used. The input resistance of the transistor is . The voltage gain of the transistor is ______.

For a transistor and are given as and . Then the correct relation between and will be:
If an emitter current is changed by 4 mA, the collector current changes by 3.5 mA. The value of will be:
3.5
0.5
0.875
7
The correct relation between (ratio of collector current to emitter current) and (ratio of collector current to base current) of a transistor is :
For a transistor in CE mode to be used as an amplifier, it must be operated in:
Cut-off region only
Saturation region only
The active region only
Both cut-off and Saturation
Given below are two statements:
Statement I: junction diodes can be used to function as a transistor, simply by connecting two diodes, back to back, which acts as the base terminal.
Statement II: In the study of transistors, the amplification factor indicates ratio of the collector current to the base current.
In the light of the above statements, choose the correct answer from the options given below.
Both Statement I and Statement II are false
Statement I is true but Statement II is false
Statement I is false but Statement II is true
Both Statement I and Statement II are true
The typical output characteristics curve for a transistor working in the common-emitter configuration is shown in the figure.
The estimated current gain from the figure is ___.
A circuit is arranged as shown in figure. The output voltage is equal to _________ V.
