RankRizz
JEE MAIN 2021 · 27 AUG S1+4 / −1EASYTRANSCRIBED

JEE Main 2021 Physics question — Transistors (older syllabus)

For a transistor in CE mode to be used as an amplifier, it must be operated in:

SOLUTION

We begin by recalling how a bipolar junction transistor (BJT) behaves in its different regions of operation. In the common-emitter (CE) configuration, the three principal regions are:

1. Cut-off\text{Cut-off} – here the base-emitter junction is reverse-biased and the collector-base junction is also reverse-biased. As a result, both the collector current ICI_C and the emitter current IEI_E are practically zero, giving no output signal.

2. Saturation\text{Saturation} – in this region both the base-emitter and the collector-base junctions are forward-biased. The transistor conducts a large current limited mainly by the external circuit, so the collector-emitter voltage VCEV_{CE} drops to a very small value, almost behaving like a closed switch.

3. Active (Forward-Active)\text{Active (Forward-Active)} – now the base-emitter junction is forward-biased while the collector-base junction remains reverse-biased. Under these conditions the transistor follows the fundamental relation

IC=βIB,I_C = \beta I_B,

where β\beta is the current gain (a constant for a given device and operating point). Because ICI_C is a faithful, almost linear, amplification of the base current IB,I_B, any small variation ΔIB\Delta I_B produces a proportionally larger variation ΔIC,\Delta I_C, giving voltage amplification across the collector resistor RC.R_C. This is precisely the behaviour required for an amplifier: linearity, predictable gain, and low distortion.

Now, let us match each option with the required characteristics:

• In cut-off, IC≈0,I_C \approx 0, so no useful amplification is possible; the output is essentially zero. Therefore cut-off is unsuitable.

• In saturation, both junctions are forward-biased, the transistor behaves like a closed switch, and VCEV_{CE} is very small. Any attempt to superimpose a small signal on this state will be severely clipped, destroying linearity. Hence saturation is also unsuitable for amplification.

• In the active region the transistor provides the linear relation IC=βIB,I_C = \beta I_B, allowing faithful reproduction and enlargement of the input signal. Consequently this is the only region in which a BJT in CE mode acts as a proper amplifier.

• The fourth choice, “both cut-off and saturation,” corresponds to switching applications (digital logic), not to linear amplification.

So, only the active region meets the requirement for CE amplification.

Hence, the correct answer is Option C.

Tagged Transistors (older syllabus). Machine-assigned, so read it as a strong shortlist rather than a verdict.

SubjectPhysics
TopicTransistors (older syllabus)
TypeMultiple choice