A cell of internal resistance r drives current through an external resistance R. The power delivered by the cell to the external resistance will be maximum when:
- A
R = 2r
- B
R = r
- C
R = 1000 r
- D
R = 0.001 r
Every JEE Main question on Electric power and heating effect of current, one of the ideas inside Current Electricity: 60 questions from 2004–2026, 25 of them in the last five years. Newest first, answer key on every one. Free to read.
Questions
60
Years asked
17
Since
2004
Of the chapter
16%
41–60 OF 60 · NEWEST FIRST
A cell of internal resistance r drives current through an external resistance R. The power delivered by the cell to the external resistance will be maximum when:
R = 2r
R = r
R = 1000 r
R = 0.001 r
The resistive network shown below is connected to a D.C. source of 16 V. The power consumed by the network is 4 Watt. The value of R is:

16 Ω
8 Ω
6 Ω
1 Ω
A current of 2 mA was passed through an unknown resistor which dissipated a power of 4.4 W. Dissipated power when an ideal power supply of 11 V is connected across it is:
W
W
W
W
A heating element has a resistance of 100 at room temperature. When it is connected to a supply of 220 V, a steady current of 2 A passes in it and temperature is 500C more than the room temperature. The temperature coefficient of resistance of the heating element is:
C
C
C
C
A constant voltage is applied between two ends of a metallic wire. If the length is halved and the radius of the wire is doubled, the rate of heat developed in the wire will be:
Increased 8 times
Doubled
Halved
Unchanged
The figure shows three circuits I, II and III which are connected to a 3 V battery. If the powers dissipated by the configurations I, II and III are , and respectively, then -

In the circuit shown, the resistance r is a variable resistance. If for , the heat generation in r is maximum then the value of f is

1
The resistance of an electrical toaster has a temperature dependence given by in its range of operation. At K, and at K, . The toaster is connected to a voltage source at 200 V and its temperature is raised at a constant rate from 300 to 500 K in 30 s. The total work done in raising the temperature is:
Note: This question was awarded as the bonus since all options were incorrect in the exam.
J
J
300 J
J
In a large building, there are 15 bulbs of 40 W, 5 bulbs of 100 W, 5 fans of 80 W and 1 heater of 1 kW. The voltage of the electric mains is 220 V. The minimum capacity of the main fuse of the building will be:
8 A
10 A
12 A
14 A
Four bulbs B, B, B and B of 100 W each are connected to 220 V main as shown in the figure. The reading in the ideal ammeter will be:

0.90 A
1.35 A
0.45 A
1.80 A
The supply voltage to a room is 120 V. The resistance of the lead wires is 6 . A 60 W bulb is already switched on. What is the decrease of voltage across the bulb, when a 240 W heater is switched on in parallel to the bulb?
13.3 V
10.4 V
zero V
2.9 V
Which of the four resistances P, Q, R and S generate the greatest amount of heat when a current flows from A to B?

Q
S
P
R
Two electric bulbs marked and are connected in series to a supply. Which of the bulbs will fuse?
both
neither
This question has Statement 1 and Statement 2. Of the four choices given after the Statements, choose the one that best describes the two Statements. Statement 1: The possibility of an electric bulb fusing is higher at the time of switching ON. Statement 2: Resistance of an electric bulb when it is not lit up is much smaller than when it is lit up.
Statement 1 is true, Statement 2 is false
Statement 1 is false, Statement 2 is true, Statement 2 is not a correct explanation of Statement 1.
Statement 1 is true, Statement 2 is true, Statement 2 is a correct explanation of Statement 1.
Statement 1 is false, Statement 2 is true.
A volt battery is connected to two light bulbs as shown in figure. Light bulb 1 has resistance ohm while light bulb 2 has resistance ohm. Battery has negligible internal resistance. Which bulb will glow brighter?

Bulb 1 will glow more first and then its brightness will become less than bulb 2
Bulb 1
Bulb 2
Both glow equally
Three resistors of and are connected in parallel and the combination is connected in series with a V battery of internal resistance. The rate of Joule heating in the resistor is
W
W
W
W
An electric bulb is rated volt watt. The power consumed by it when operated on volt will be
50 watt
75 watt
40 watt
25 watt
A heater coil is cut into two equal parts and only one part is now used in the heater. The heat generated will now be
doubled
four times
one fourth
halved
The resistance of hot tungsten filament is about times the cold resistance. What will be the resistance of W and V lamp when not in use?
The thermo emf of a thermocouple varies with the temperature of the hot junction as in volts where the ratio is C. If the cold junction is kept at C, then the neutral temperature is
C
C
C
no neutral temperature is possible for this thermocouple.
RELATED CURRENT ELECTRICITY TOPICS