A battery with EMF E and internal resistance r is connected across a resistance R. The power consumption in R will be maximum when :
- A
R=r
- B
- C
- D
R=2r
Every JEE Main question on Electric power and heating effect of current, one of the ideas inside Current Electricity: 60 questions from 2004–2026, 25 of them in the last five years. Newest first, answer key on every one. Free to read.
Questions
60
Years asked
17
Since
2004
Of the chapter
16%
Questions on Electric power and heating effect of current in each year it was asked, the latest 12 of 17.
1–20 OF 60 · NEWEST FIRST
A battery with EMF E and internal resistance r is connected across a resistance R. The power consumption in R will be maximum when :
R=r
R=2r
An electric power line having total resistance of , delivers 1 kW of power at 250 V. The percentage efficiency of transmission line is ____ .
92.5
100
86.5
96.9
Refer to the circuit diagram given below. The heat generated across the 6 resistance in 100 second is J. The value of is _______. (Nearest integer)

The heat generated in 1 minute between points A and B in the given circuit, when a battery of 9 V with internal resistance of 1Ω is connected across these points is ____ J

There are 'n' number of identical electric bulbs, each is designed to draw a power p independently from the mains supply. They are now joined in series across the main supply. The total power drawn by the combination is :
A motor operating on 100 V draws a current of 1 A. If the efficiency of the motor is 91.6%, then the loss of power in units of cal/s is
4
8.4
2
6.2
When a potential difference is applied across a wire of resistance , it dissipates energy at a rate . If the wire is cut into two halves and these halves are connected mutually parallel across the same supply, the energy dissipation rate will become:
By what percentage will the illumination of the lamp decrease if the current drops by 20%?
46%
26%
36%
56%
The number of electrons flowing per second in the filament of a bulb operating at is : (Given )
An electric toaster has resistance of at room temperature . The toaster is connected to a supply. If the current flowing through it reaches , the temperature attained by toaster is around: (if )
An electric bulb rated W V is connected across a V supply. The power dissipation of the bulb is:
W
W
W
W
The ratio of heat dissipated per second through the resistors and in the circuit given below is

Water boils in an electric kettle in 20 minutes after being switched on. Using the same main supply, the length of the heating element should be _____ to _____ times of its initial length if the water is to be boiled in 15 minutes.
decreased, 3/4
increased, 4/3
decreased, 4/3
increased, 3/4
In the following circuit, the battery has an emf of 2 V and an internal resistance of . The power consumption in the entire circuit is ______ W.

A heater is designed to operate with a power of 1000 W in a 100 V line. It is connected in combination with a resistance of and a resistance , to a 100 V mains as shown in figure. For the heater to operate at 62.5 W, the value of should be _____

Ratio of thermal energy released in two resistor and connected in parallel in an electric circuit is:
The amount of thermal energy is developed by a resistor in 10 s when a current of 4 A is passed through it. If the current is increased to 16 A, the thermal energy developed by the resistor in 10 s will be
Two identical heater filaments are connected first in parallel and then in series. At the same applied voltage, the ratio of heat produced in same time for parallel to series will be:
1 : 4
4 : 1
2 : 1
1 : 2
Different combination of 3 resistors of equal resistance are shown in the figures. The increasing order for power dissipation is:
(A)
(B)
(C)
(D)

A potential is applied across a uniform wire of resistance . The power dissipation is . The wire is then cut into two equal halves and a potential of is applied across the length of each half. The total power dissipation across two wires is . The ratio of is . The value of is _____.
RELATED CURRENT ELECTRICITY TOPICS