RankRizzStart free

Current Electricity — JEE Main Previous Year Questions

Every Current Electricity question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 386 questions across 10 distinct ideas. Free to read, answer key on every one.

Questions

386

Distinct ideas

10

Share of marks

5.6%

Difficulty

MEDIUM

The ideas inside Current Electricity

A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Current Electricity questions actually test.

01Electric current, current density and drift velocityset 24×
02Ohm's law, resistance, resistivity and colour codeset 51×
03Combination of resistors and equivalent resistanceset 49×
04Cells: emf, internal resistance and combinationsset 27×
05Kirchhoff's laws and circuit analysisset 49×
06Wheatstone bridgeset 14×
07Meter bridgeset 23×
08Potentiometerset 29×
09Electric power and heating effect of currentset 60×
10Galvanometer conversion to ammeter and voltmeterset 60×

Every Current Electricity question

341–360 OF 386 · NEWEST FIRST

JEE MAIN 2013 · 07 APR ONLINEElectric power and heating effect of currentTRANSCRIBED

The supply voltage to a room is 120 V. The resistance of the lead wires is 6 . A 60 W bulb is already switched on. What is the decrease of voltage across the bulb, when a 240 W heater is switched on in parallel to the bulb?

  1. A

    13.3 V

  2. B

    10.4 V

  3. C

    zero V

  4. D

    2.9 V

JEE MAIN 2013 · 09 APR ONLINEMeter bridgeTRANSCRIBED

In a metre bridge experiment null point is obtained at 40 cm from one end of the wire when resistance X is balanced against another resistance Y. If X < Y, then the new position of the null point from the same end, if one decides to balance a resistance of 3X against Y, will be close to :

  1. A

    80 cm

  2. B

    75 cm

  3. C

    67 cm

  4. D

    50 cm

JEE MAIN 2013 · 25 APR ONLINECombination of resistors and equivalent resistanceTRANSCRIBED

Six equal resistances are connected between points P, Q and R as shown in the figure. Then net resistance will be maximum between :

  1. A

    P and R

  2. B

    P and Q

  3. C

    Q and R

  4. D

    Any two points

JEE MAIN 2013 · 07 APR ONLINEGalvanometer conversion to ammeter and voltmeterTRANSCRIBED

This question has Statement I and Statement II. Of the four choices given after the Statements, choose the one that best describes the two Statements.
Statement - I : Higher the range, greater is the resistance of ammeter.
Statement - II : To increase the range of ammeter, additional shunt needs to be used across it.

  1. A

    Statement-I is true, Statement-II is false.

  2. B

    Statement-I is false, Statement-II is true.

  3. C

    Statement-I is true, Statement-II is true, Statement-II is the correct explanation of Statement-I.

  4. D

    Statement-I is true, Statement-II is true, Statement-II is not the correct explanation of Statement-I.

JEE MAIN 2013 · 09 APR ONLINECombination of resistors and equivalent resistanceTRANSCRIBED

A letter 'A' is constructed of a uniform wire with resistance 1.0 per cm. The sides of the letter are 20 cm and the cross piece in the middle is 10 cm long. The apex angle is 60°. The resistance between the ends of the legs is close to:

  1. A

    50.0

  2. B

    10

  3. C

    36.7

  4. D

    26.7

JEE MAIN 2013 · 22 APR ONLINEKirchhoff's laws and circuit analysisTRANSCRIBED

A dc source of emf V and internal resistance , a storage battery of emf V and an external resistance R are connected as shown in figure. For what value of R no current will pass through the battery?

image
  1. A

    5.5

  2. B

    3.5

  3. C

    4.5

  4. D

    2.5

JEE MAIN 2013 · 09 APR ONLINEGalvanometer conversion to ammeter and voltmeterTRANSCRIBED

A shunt of resistance 1 is connected across a galvanometer of 120 resistance. A current of 5.5 ampere gives full scale deflection in the galvanometer. The current that will give full scale deflection in the absence of the shunt is nearly :

  1. A

    5.5 ampere

  2. B

    0.5 ampere

  3. C

    0.004 ampere

  4. D

    0.045 ampere

JEE MAIN 2013 · 22 APR ONLINEGalvanometer conversion to ammeter and voltmeterTRANSCRIBED

To find the resistance of a galvanometer by the half deflection method, the following circuit is used with resistances ,   and . The deflection in the galvanometer is d. With , the deflection changed to . The galvanometer resistance is approximately:

  1. A

    107

  2. B

    137

  3. C

    107/2

  4. D

    77

JEE MAIN 2013 · 23 APR ONLINEElectric power and heating effect of currentTRANSCRIBED

Which of the four resistances P, Q, R and S generate the greatest amount of heat when a current flows from A to B?

  1. A

    Q

  2. B

    S

  3. C

    P

  4. D

    R

JEE MAIN 2013 · 23 APR ONLINEOhm's law, resistance, resistivity and colour codeTRANSCRIBED

Correct set up to verify Ohm's law is :

  1. A
  2. B
  3. C
  4. D
JEE MAIN 2012Electric power and heating effect of currentTRANSCRIBED

Two electric bulbs marked and are connected in series to a supply. Which of the bulbs will fuse?

  1. A

    both

  2. B

  3. C

  4. D

    neither

JEE MAIN 2012Electric power and heating effect of currentTRANSCRIBED

This question has Statement 1 and Statement 2. Of the four choices given after the Statements, choose the one that best describes the two Statements. Statement 1: The possibility of an electric bulb fusing is higher at the time of switching ON. Statement 2: Resistance of an electric bulb when it is not lit up is much smaller than when it is lit up.

  1. A

    Statement 1 is true, Statement 2 is false

  2. B

    Statement 1 is false, Statement 2 is true, Statement 2 is not a correct explanation of Statement 1.

  3. C

    Statement 1 is true, Statement 2 is true, Statement 2 is a correct explanation of Statement 1.

  4. D

    Statement 1 is false, Statement 2 is true.

JEE MAIN 2012Ohm's law, resistance, resistivity and colour codeTRANSCRIBED

The resistance of a wire is . It is bent at the middle by and both the ends are twisted together to make a shorter wire. The resistance of the new wire is

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2012PotentiometerTRANSCRIBED

In an experiment of potentiometer for measuring the internal resistance of primary cell a balancing length is obtained on the potentiometer wire when the cell is open circuit. Now the cell is short circuited by a resistance . If is to be equal to the internal resistance of the cell the balancing length on the potentiometer wire will be

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2012Electric power and heating effect of currentTRANSCRIBED

A volt battery is connected to two light bulbs as shown in figure. Light bulb 1 has resistance ohm while light bulb 2 has resistance ohm. Battery has negligible internal resistance. Which bulb will glow brighter?

image
  1. A

    Bulb 1 will glow more first and then its brightness will become less than bulb 2

  2. B

    Bulb 1

  3. C

    Bulb 2

  4. D

    Both glow equally

JEE MAIN 2012Cells: emf, internal resistance and combinationsTRANSCRIBED

A generator has armature resistance of and develops an induced emf of V when driven at its rated speed. Its terminal voltage when a current of A is being drawn is

  1. A

    V

  2. B

    V

  3. C

    V

  4. D

    V

JEE MAIN 2012Electric power and heating effect of currentTRANSCRIBED

Three resistors of and are connected in parallel and the combination is connected in series with a V battery of internal resistance. The rate of Joule heating in the resistor is

  1. A

    W

  2. B

    W

  3. C

    W

  4. D

    W

JEE MAIN 2012PotentiometerTRANSCRIBED

It is preferable to measure the e.m.f. of a cell by potentiometer than by a voltmeter because of the following possible reasons. (i) In case of potentiometer, no current flows through the cell. (ii) The length of the potentiometer allows greater precision. (iii) Measurement by the potentiometer is quicker. (iv) The sensitivity of the galvanometer, when using a potentiometer is not relevant. Which of these reasons are correct?

  1. A

    (i),(iii),(iv)

  2. B

    (i),(iii),(iv) only

  3. C

    (i),(ii)

  4. D

    (i),(ii),(iii),(iv)

JEE MAIN 2012Meter bridgeTRANSCRIBED

In a sensitive meter bridge apparatus the bridge wire should possess

  1. A

    high resistivity and low temperature coefficient.

  2. B

    low resistivity and high temperature coefficient.

  3. C

    low resistivity and low temperature coefficient.

  4. D

    high resistivity and high temperature coefficient.

JEE MAIN 2011Ohm's law, resistance, resistivity and colour codeTRANSCRIBED

If a wire is stretched to make it longer, its resistance will:

  1. A

    increase by

  2. B

    decrease by

  3. C

    decrease by

  4. D

    increase by