Drift speed of electrons, when 1.5 A current flows in a copper wire of cross section 5 mm is . If the electron density in copper is m, the value of in mm s is close to (Take charge of an electron to be C)
- A
0.2
- B
3
- C
2
- D
0.02
Every JEE Main question on Electric current, current density and drift velocity, one of the ideas inside Current Electricity: 24 questions from 2008–2026, 14 of them in the last five years. Newest first, answer key on every one. Free to read.
Questions
24
Years asked
10
Since
2008
Of the chapter
6%
21–24 OF 24 · NEWEST FIRST
Drift speed of electrons, when 1.5 A current flows in a copper wire of cross section 5 mm is . If the electron density in copper is m, the value of in mm s is close to (Take charge of an electron to be C)
0.2
3
2
0.02
A copper rod of cross-sectional area A carries a uniform current I through it. At temperature T, if the volume charge density of the rod is , how long will the charges take to travel a distance d?
Suppose the drift velocity in a material varied with the applied electric field E as . Then V - I graph for a wire made of such a material is best given by:




Paragraph: Consider a block of conducting material of resistivity '' shown in the figure. Current '' enters at '' and leaves from ''. We apply superposition principle to find voltage '' developed between '' and ''. The calculation is done in the following steps: (i) Take current '' entering from '' and assume it to spread over a hemispherical surface in the block. (ii) Calculate field at distance '' from by using Ohm's law , where is the current per unit area at ''. (iii) From the '' dependence of , obtain the potential at . (iv) Repeat (i), (ii) and (iii) for current '' leaving '' and superpose results for '' and ''.
Question: For current entering at , the electric field at a distance '' from is
RELATED CURRENT ELECTRICITY TOPICS