A cube has side length 5 cm and modulus of rigidity N/m. The displacement produced by a force of 10 N in the upper face of cube is _______ mm.
Every JEE Main question on Modulus of rigidity and Poisson's ratio, one of the ideas inside Mechanical Properties of Solids: 10 questions from 2013–2026, 5 of them in the last five years. Newest first, answer key on every one. Free to read.
Questions
10
Years asked
8
Since
2013
Of the chapter
8%
Questions on Modulus of rigidity and Poisson's ratio in each year it was asked.
1–10 OF 10 · NEWEST FIRST
A cube has side length 5 cm and modulus of rigidity N/m. The displacement produced by a force of 10 N in the upper face of cube is _______ mm.
A cylindrical rod of length 1 m and radius 4 cm is mounted vertically. It is subjected to a shear force of N at the top. Considering infinitesimally small displacement in the upper edge, the angular displacement of the rod axis from its original position would be : (shear moduli, N/m)
Two slabs with square cross section of different materials (1, 2) with equal sides () and thickness and such that and . Considering lower edges of these slabs are fixed to the floor, we apply equal shearing force on the narrow faces. The angle of deformation is . If the shear moduli of material 1 is N/m, then shear moduli of material 2 is , where value of x is ________.
Choose the correct relationship between Poisson ratio , bulk modulus and modulus of rigidity of a given solid object:
A square aluminium (shear modulus is ) slab of side and thickness is subjected to a shearing force (on its narrow face) of . The lower edge is riveted to the floor. The displacement of the upper edge is ______ .
If , and are the values of Young's modulus, bulk modulus and modulus of rigidity of any material respectively. Choose the correct relation for these parameters.
N m
N m
N m
N m
As shown in the figure, forces of N each are applied in opposite directions, on the upper and lower faces of a cube of side 10 cm, shifting the upper face parallel to itself by 0.5 cm. If the side of another cube of the same material is, 20 cm then under similar conditions as above, the displacement will be:

1.00 cm
0.25 cm
0.37 cm
0.75 cm
In materials like aluminium and copper, the correct order of magnitude of various elastic modulii is:
Young's modulii < shear modulii < bulk modulii
Bulk modulii < shear modulii < Young's modulii
Shear modulii < Young's modulii < bulk modulii
Bulk modulii < Young's modulii < shear modulii
Steel ruptures when a shear of N m is applied. The force needed to punch a 1 cm diameter hole in a steel sheet 0.3 cm thick is nearly:
N
N
N
N
A uniform wire (Young's modulus Nm) is subjected to longitudinal tensile stress of Nm. If the overall volume change in the wire is 0.02%, the fractional decrease in the radius of the wire is close to: