RankRizzStart free

Alternating Current — JEE Main Previous Year Questions

Every Alternating Current question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 165 questions across 7 distinct ideas. Free to read, answer key on every one.

Questions

165

Distinct ideas

7

Share of marks

2%

Difficulty

EASY

The ideas inside Alternating Current

A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Alternating Current questions actually test.

01AC basics: rms and average values, phasorsset 1×
02AC through resistor, inductor and capacitorset 6×
03Series LCR circuits: impedance and phaseset 121×
04Resonance, bandwidth and quality factorset 16×
05Power in AC circuits and power factorset 3×
06LC oscillationsset 2×
07AC generator and transformerset 16×

Every Alternating Current question

141–160 OF 165 · NEWEST FIRST

JEE MAIN 2017 · 09 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

A sinusoidal voltage of peak value 283 V and angular frequency 320 s is applied to a series LCR circuit. Given that , mH and F. The total impedance and phase difference between the voltage across the source and the current will respectively be-

  1. A

    10 and

  2. B

    7 and 45°

  3. C

    7 and

  4. D

    10 and

JEE MAIN 2016 · 03 APR OFFLINESeries LCR circuits: impedance and phaseTRANSCRIBED

An arc lamp requires a direct current of 10 A at 80 V to function. If it is connected to a 220 V (rms), 50 Hz AC supply, the series inductor needed for it to work is close to:

  1. A

    0.044 H

  2. B

    0.065 H

  3. C

    80 H

  4. D

    0.08 H

JEE MAIN 2015 · 11 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

The AC voltage across a resistance can be measured using a:

  1. A

    Moving magnet galvanometer

  2. B

    Moving coil galvanometer

  3. C

    Hot wire voltmeter

  4. D

    Potentiometer

JEE MAIN 2015 · 11 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

For the LCR circuit, shown here, the current is observed to lead the applied voltage. An additional capacitor , when joined with the capacitor C present in the circuit, makes the power factor of the circuit unity. The capacitor , must have been connected in:

  1. A

    Parallel with C and has a magnitude

  2. B

    Series with C and has a magnitude

  3. C

    Series with C and has a magnitude

  4. D

    Parallel with C and has a magnitude

JEE MAIN 2014 · 09 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

When the rms voltages , and are measured respectively across the inductor L, the capacitor C and the resistor R in a series LCR circuit connected to an AC source, it is found that the ratio . If the rms voltage of the AC source is 100 V, then is close to:

  1. A

    50 V

  2. B

    70 V

  3. C

    100 V

  4. D

    95 V

JEE MAIN 2014 · 12 APR ONLINEResonance, bandwidth and quality factorTRANSCRIBED

A sinusoidal voltage V(t) = 100 sin(500t) is applied across a pure inductance of L = 0.02H. The current through the coil is:

  1. A

    10 cos(500t)

  2. B

    cos(500t)

  3. C

    10 sin(500t)

  4. D

    sin(500t)

JEE MAIN 2013 · 25 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

When resonance is produced in a series LCR circuit, then which of the following is not correct?

  1. A

    Current in the circuit is in phase with the applied voltage.

  2. B

    Inductive and capacitive reactances are equal.

  3. C

    If R is reduced, the voltage across capacitor will increase.

  4. D

    Impedance of the circuit is maximum.

JEE MAIN 2013 · 22 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

An LCR circuit as shown in the figure is connected to a voltage source whose frequency can be varied. The frequency, at which the voltage across the resistor is maximum, is :

  1. A

    902 Hz

  2. B

    143 Hz

  3. C

    23 Hz

  4. D

    345 Hz

JEE MAIN 2013 · 23 APR ONLINEResonance, bandwidth and quality factorTRANSCRIBED

The plot given below is of the average power delivered to an LRC circuit versus frequency. The quality factor of the circuit is :

  1. A

    5.0

  2. B

    2.0

  3. C

    2.5

  4. D

    0.4

JEE MAIN 2013 · 25 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

A series LR circuit is connected to an ac source of frequency and the inductive reactance is equal to 2R. A capacitance of capacitive reactance equal to R is added in series with L and R. The ratio of the new power factor to the old one is :

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2013 · 09 APR ONLINESeries LCR circuits: impedance and phaseTRANSCRIBED

In the circuit shown here, the voltage across E and C are respectively 300 V and 400 V. The voltage E of the ac source is :

  1. A

    400 Volt

  2. B

    500 Volt

  3. C

    100 Volt

  4. D

    700 Volt

JEE MAIN 2013 · 22 APR ONLINEResonance, bandwidth and quality factorTRANSCRIBED

In a series L - C - R circuit, Farad, Henry and Ohm, when a constant D.C. voltage E is applied to the circuit, the capacitor acquires a charge C. The D.C. source is replaced by a sinusoidal voltage source in which the peak voltage is equal to the constant D.C. voltage E. At resonance the peak value of the charge acquired by the capacitor will be :

  1. A

    C

  2. B

    C

  3. C

    C

  4. D

    C

JEE MAIN 2012Series LCR circuits: impedance and phaseTRANSCRIBED

In an circuit shown in the following figure, what will be the readings of the voltmeter across the resistor and ammeter if an a.c. source of 220 V and 100 Hz is connected to it as shown?

image
  1. A

    800 V, 8 A

  2. B

    110 V, 1.1 A

  3. C

    300 V, 3 A

  4. D

    220 V, 2.2 A

JEE MAIN 2012LC oscillationsTRANSCRIBED

The capacitor of an oscillatory circuit is enclosed in a container. When the container is evacuated, the resonance frequency of the circuit is 10 kHz. When the container is filled with a gas, the resonance frequency changes by 50 Hz. The dielectric constant of the gas is

  1. A

    1.001

  2. B

    2.001

  3. C

    1.01

  4. D

    3.01

JEE MAIN 2011LC oscillationsTRANSCRIBED

A fully charged capacitor with initial charge is connected to a coil of self inductance at . The time at which the energy is stored equally between the electric and the magnetic fields is:

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2010Power in AC circuits and power factorTRANSCRIBED

In a series LCR circuit and the voltage and the frequency of the main supply is V and Hz respectively. On taking out the capacitance from the circuit the current lags behind the voltage by . On taking out the inductor from the circuit the current leads the voltage by . The power dissipated in the LCR circuit is

  1. A

    W

  2. B

    W

  3. C

    Zero W

  4. D

    W

JEE MAIN 2007Power in AC circuits and power factorTRANSCRIBED

In an a.c. circuit the voltage applied is . The resulting current in the circuit is . The power consumption in the circuit is given by

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2006AC generator and transformerTRANSCRIBED

In an AC generator, a coil with turns, all of the same area and total resistance , rotates with frequency in a magnetic field . The maximum value of emf generated in the coil is

  1. A

  2. B

  3. C

  4. D

JEE MAIN 2006Resonance, bandwidth and quality factorTRANSCRIBED

In a series resonant LCR circuit, the voltage across is volts and with . The resonant frequency is . At resonance the voltage across is

  1. A

  2. B

  3. C

    40 V

  4. D

    250 V

JEE MAIN 2005Resonance, bandwidth and quality factorTRANSCRIBED

The self inductance of the motor of an electric fan is H. In order to impart maximum power at Hz, it should be connected to a capacitance of

  1. A

  2. B

  3. C

  4. D