A bulb and a capacitor are connected in series across an ac supply. A dielectric is then placed between the plates of the capacitor. The glow of the bulb:
- A
increases
- B
decreases
- C
remains same
- D
becomes zero
Every Alternating Current question JEE Main has set, grouped by the idea it tests rather than the order of the syllabus. 165 questions across 7 distinct ideas. Free to read, answer key on every one.
Questions
165
Distinct ideas
7
Share of marks
2%
Difficulty
EASY
A chapter is not one subject — it is a handful of procedures the examiner reuses. These are the ones Alternating Current questions actually test.
21–40 OF 165 · NEWEST FIRST
A bulb and a capacitor are connected in series across an ac supply. A dielectric is then placed between the plates of the capacitor. The glow of the bulb:
increases
decreases
remains same
becomes zero
An alternating voltage volt is applied to a purely resistive load of . The time taken for the current to rise from half of the peak value to the peak value is:
5 ms
3.3 ms
7.2 ms
2.2 ms
The primary side of a transformer is connected to 230 V, 50 Hz supply. The turn ratio of primary to secondary winding is 10 : 1. Load resistance connected to the secondary side is 46 . The power consumed in it is :
12.5 W
10.0 W
11.5 W
12.0 W
In an a.c. circuit, voltage and current are given by: V and mA respectively. The average power dissipated in one cycle is:
W
W
W
W
A series circuit connected with an ac source has a power factor of . If the source of emf is changed to , the new power factor of the circuit will be :
An AC voltage is applied to a series LCR circuit which drives a current . The average power dissipated is:
21.6 W
200 W
173.2 W
50 W
Match List I with List II:
Choose the correct answer from the options given below:
A-I, B-IV, C-II, D-III
A-IV, B-I, C-II, D-III
A-IV, B-I, C-III, D-II
A-I, B-IV, C-III, D-II
A series LCR circuit is subjected to an ac signal of V, Hz. If the voltage across the inductor is V, then the current in this circuit is :
A
A
A
mA
Given below are two statements: Statement I: In an LCR series circuit, current is maximum at resonance. Statement II: Current in a purely resistive circuit can never be less than that in a series LCR circuit when connected to same voltage source. In the light of the above statements, choose the correct from the options given below:
Statement I is false but Statement II is true
Statement I is true but Statement II is false
Both Statement I and Statement II are true
Both Statement I and Statement II are false
A LCR circuit is at resonance for a capacitor , inductance and resistance . Now the value of resistance is halved keeping all other parameters same. The current amplitude at resonance will be now:
Zero
same
halved
double
A coil of negligible resistance is connected in series with resistor across V, Hz supply. A voltmeter reads V across resistance. Inductance of the coil is :
0.286 H
0.76 H
2.86 H
0.91 H
In an ac circuit, the instantaneous current is zero, when the instantaneous voltage is maximum. In this case, the source may be connected to: A. pure inductor. B. pure capacitor. C. pure resistor. D. combination of an inductor and capacitor. Choose the correct answer from the options given below :
A, B and C only
A and B only
B, C and D only
A, B and D only
In series LCR circuit, the capacitance is changed from to . To keep the resonance frequency unchanged, the new inductance should be :
reduced by
increased by
reduced by
increased to
A transformer has an efficiency of 80% and works at 10 V and 4 kW. If the secondary voltage is 240 V, then the current in the secondary coil is:
1.59 A
13.33 A
1.33 A
15.1 A
Primary coil of a transformer is connected to . Primary and secondary turns of the transforms are and respectively. Secondary coil of transformer is connected to two series resistances as shown in figure. The output voltage is :

A alternating current at any instant is given by . The rms value of the current is ______ A.
A series LCR circuit with mH, F and , is connected across an AC source of 220 V, 50 Hz supply. The power factor of the circuit would be _____.
An ac source is connected in given series LCR circuit. The rms potential difference across the capacitor of is ______ V.

When a dc voltage of is applied to an inductor, a dc current of flows through it. When an ac voltage of peak value is connected to inductor, its inductive reactance is found to be . The power dissipated in the circuit is _______ W.
For a given series LCR circuit it is found that maximum current is drawn when value of variable capacitance is . If resistance of and inductor is being used in the given circuit. The frequency of ac source is ___________ . (given )
OTHER PHYSICS CHAPTERS