RankRizz
JEE MAIN 2016 · 09 APR ONLINE+4 / −1EASYTRANSCRIBED

JEE Main 2016 Physics question — Transistors (older syllabus)

An unknown transistor needs to be identified as a npn or pnp type. A multimeter, with +ve and -ve terminals, is used to measure resistance between different terminals of transistor. If terminal 2 is the base of the transistor then which of the following is correct for a pnp transistor?

SOLUTION

First, recall the basic structure of a bipolar junction transistor. In a pnppnp device the sequence of semiconductor types from emitter to collector is p  −  n  −  pp \; - \; n \; - \; p. Therefore

Emitter (E):p-type,Base (B):n-type,Collector (C):p-type.\text{Emitter (E)} : p\text{-type}, \qquad \text{Base (B)} : n\text{-type}, \qquad \text{Collector (C)} : p\text{-type}.

A multimeter in the resistance (or diode-test) mode applies a small d.c. voltage internally: its red lead is at a higher potential than its black lead. So

Red lead=+ve,Black lead=−ve.\text{Red lead} = +\text{ve}, \qquad \text{Black lead} = -\text{ve}.

For a single pp-nn junction we have the standard diode rule:

When pp-side is connected to the positive lead and nn-side to the negative lead, the junction is forward biased and the meter shows a low resistance.
When the polarities are reversed, the junction is reverse biased and the meter shows a high resistance.

Now, in a transistor there are two separate pp-nn junctions: the emitter-base junction and the collector-base junction. Because the base of a pnppnp transistor is nn-type, both of those junctions have the nn-type side at the base.

We are told that terminal 2 is the base. Let us examine the four possible measurements one by one, always applying the diode rule stated above.

Case A: (+ve lead on 2, -ve lead on 3)\text{(+ve lead on 2, -ve lead on 3)}
Base (n) is at positive potential, terminal 3 (p) is at negative potential, so the junction is reverse biased. Hence the resistance must be high, not low. So statement A is incorrect.

Case B: (+ve lead on 2, -ve lead on 1)\text{(+ve lead on 2, -ve lead on 1)}
Again the base (n) is positive and terminal 1 (p) is negative, giving reverse bias and therefore a high resistance. This agrees with what is written in option B, so option B is consistent.

Case C: (+ve lead on 1, -ve lead on 2)\text{(+ve lead on 1, -ve lead on 2)}
Now terminal 1 (p) is positive and the base (n) is negative, so the emitter-base junction is forward biased. The meter should show a low resistance, but option C claims it is high; hence option C is wrong.

Case D: (+ve lead on 3, -ve lead on 2)\text{(+ve lead on 3, -ve lead on 2)}
Here terminal 3 (p) is positive and the base (n) is negative, producing forward bias on the collector-base junction. The resistance should be low, yet option D says it is high, so option D is also wrong.

Among the four possibilities, only option B matches the correct behaviour of the two pp-nn junctions in a pnppnp transistor when the meter leads are connected as stated.

Hence, the correct answer is Option B.

Tagged Transistors (older syllabus). Machine-assigned, so read it as a strong shortlist rather than a verdict.

SubjectPhysics
TopicTransistors (older syllabus)
TypeMultiple choice