The ratio (R) of output resistance , and the input resistance in measurements of input and output characteristics of a transistor is typically in the range:
We begin by recalling the definitions of the two small-signal resistances that are measured on the common-emitter characteristics of a transistor.
By definition, the input resistance is
where is the base-emitter voltage and is the base current. This differential resistance is evaluated on the family of input (base) characteristics. For a silicon transistor biased in its normal active region, the slope is quite steep, so the reciprocal slope, which is the resistance , is comparatively small. Empirically one encounters
though values up to a few hundred ohms are also seen, depending on bias current.
Next, the output resistance is
with the collector-emitter voltage and the collector current. In the active region, the collector current varies only slightly with , so the slope is very small and its reciprocal is therefore quite large. Typical experimentally measured values are
We are interested in the ratio
Substituting the representative numerical ranges just quoted, we write
Carrying out the division at the two extremes, we obtain
Thus, in typical bias conditions the ratio lies in the decade centred around , most commonly between and . Expressed as an approximate range we can therefore write
Comparing this theoretical-empirical result with the choices given, we see that it matches the first option.
Hence, the correct answer is Option A.
Tagged Transistors (older syllabus). Machine-assigned, so read it as a strong shortlist rather than a verdict.