JEE MAIN 2016 · 09 APR ONLINE+4 / −1MEDIUMTRANSCRIBED
JEE Main 2016 Physics question — Galvanometer conversion to ammeter and voltmeter
A 50 Ω resistance is connected to a battery of 5 V. A galvanometer of resistance 100 Ω is to be used as an ammeter to measure current through the resistance, for this a resistance rS is connected to the galvanometer. Which of the following connections should be employed if the measured current is with in 1% of the current without the ammeter in the circuit?
SOLUTION
We have a battery of e.m.f. E=5 V connected to a load resistance R=50Ω.
If no ammeter is present, the only resistance in the circuit is this 50 Ω resistor, so the current is obtained from Ohm’s law I0=RE.
Substituting the given numbers,
I0=50Ω5 V=0.10A
So the true current is 0.10A=100mA.
We now examine each proposed ammeter construction. In every case the ammeter is inserted in series with the 50 Ω resistor, so the total circuit resistance becomes
Rtotal=R+Rammeter.
The requirement is that the current with the ammeter, I, must differ from I0 by less than 1 %, i.e.
I0I−I0<0.01.
The galvanometer resistance is Rg=100Ω.
We consider the four possibilities one by one.
Option A: rS=0.5Ω in series with galvanometer
Series combination: Rammeter=Rg+rS=100+0.5=100.5Ω.
Total resistance: Rtotal=50+100.5=150.5Ω.
Current: I=RtotalE=150.55A≈0.0332A.
Percentage error: 0.100.10−0.0332×100%≈66.8%. This is far larger than 1 %, so Option A is rejected.
Option B: rS=1Ω in series with galvanometer
Series combination: Rammeter=100+1=101Ω.
Total resistance: 50+101=151Ω.
Current: I=1515A≈0.0331A.
Error again exceeds 66 %, so Option B fails the requirement.
Option C: rS=1Ω in parallel with galvanometer
For two resistances in parallel the equivalent resistance is given by
Req=Rg+rSRgrS.
Substituting Rg=100Ω and rS=1Ω,
Rammeter=Req=100+1100×1Ω=101100Ω≈0.990Ω.
Total resistance: Rtotal=50+0.990=50.990Ω.
Current: I=50.9905A≈0.0981A.
Percentage error: 0.100.10−0.0981×100%≈1.9%, which is >1 %, so Option C is not acceptable.